Create a ProModel simulation for an existing factory layout in AutoCAD or Inventor - Quiz

Create a ProModel simulation for an existing factory layout in AutoCAD or Inventor - Quiz

Required for course completion

6 questions

What are the steps that you would take if you need to modify the location of machinery in your workflow?

(Select one)
Select an answer

In ProModel, what tool can be used to view a walkthrough to see how your materials flow through the different machinery in a digital twin of your factory?

(Select one)
Select an answer

In which of the following software do you work on your master layout as well as make any changes to your layout? (Select two.)

Select up to 2
Select an answer

In ProModel, all assets that are used in the simulation are marked with a red and white X.

(Select one)
Select an answer

In ProModel, which command would you select to be able to see the actual process flow of your factory setup?

(Select one)
Select an answer

In which of the four tabs in the Simulation Browser can you add factory assets that can later be used in ProModel?

(Select one)
Select an answer

6/6 questions left unanswered

Was this information helpful?