Module
20 min.
Use Autodesk Factory Assets in Vault
Module overview
This module covers the use of local and cloud Factory Assets in Vault.
This module takes approximately 20 minutes to complete. By the end of the 5-module journey, you will acquire the following skills:
- Set up and configure your own Factory Design implementation
- Understand factory design workflows: Inventor, AutoCAD, and Vault
- Start using Asset library
About the author
The module was prepared by Stephen Porath, the designated support specialist here at Autodesk.
Before you start
- Make sure you have AutoCAD and Factory Design Utilities installed. Refer to module 1 to learn how to do it.
- If you have technical difficulties, please reach out to product support.