Module
15 min.
Analyze the Bridge in InfraWorks
Module overview
A preliminary analysis can be done on the bridge inside InfraWorks to analyze line girders to make sure they satisfy the design requirements. Learn how to run a line girder analysis and a refined analysis before sending the bridge to the Autodesk Structural Bridge Design software for a detailed analysis.
This module takes approximately 15 minutes to complete. By the end, you should be able to:
- Run a line girder analysis.
- Run a refined analysis on the bridge in InfraWorks.
Module pre-requisites
This module requires user-level knowledge of InfraWorks and is focused on best practices and its industry applications. If you don't have experiences with this product, we recommend you to take foundational training using one of the resources below:
- Built-in tutorials, available via in-product Help
- eLearning Partners
- Authorized Training Centers
About the author
This module was created by Russ Nicloy, Civil Solutions Specialist.
Before you start
- Please make sure you have the Infraworks software loaded.
- If you have technical difficulties, please reach out to product support.
Module downloads
These downloadable resources will be used to complete units in this module: