Module
15 min.
Tolerance Analysis
Module overview
In this module, you will learn to set up tolerance analysis, validate the settings, set up an analysis using the assembly constraints, modify the tolerances, and then compare results.
This module takes approximately 15 minutes to complete.
Module pre-requisites
This module requires user-level knowledge of Inventor and is focused on best practices and its industry applications. If you don't have experiences with this product, we recommend you to take foundational training using one of the resources below:
- Built-in tutorials, available via in-product Help
- eLearning Partners
- Authorized Training Centers
About the author
This module was created by Thom Tremblay.
Before you start
- Please make sure you have the Inventor software loaded.
- If you have technical difficulties, please reach out to product support.
Module downloads
These downloadable resources will be used to complete units in this module: