Module
15 min.
Create detailed 3D annotations
Module overview
In this content series, you will learn to define feature datums, add tolerance ranges, place surface callouts, and rewind the tolerance adviser.
This content series takes approximately 15 minutes to complete.
Prerequisites
This content series requires user-level knowledge of Inventor and is focused on best practices and its industry applications. If you don't have experiences with this product, we recommend you to take foundational training using one of the resources below:
- Built-in tutorials, available via in-product Help
- eLearning Partners
- Authorized Training Centers
About the author
This content series was created by Thom Tremblay.
Before you start
- Please make sure you have the Inventor software loaded.
- If you have technical difficulties, please reach out to product support.
Module downloads
These downloadable resources will be used to complete units in this module: