Reviewing results with the Attribute tab

Any referenced datasets can be downloaded from "Module downloads" in the module overview.

Video quiz

Required for course completion

After a steady state simulation has been run successfully, if you do not need a text report, where can you review the results?

(Select one)
Select an answer

1/1 questions left unanswered

Step-by-step:

At the end of this tutorial, you will be able to review steady state simulation results using the Attribute tab of the Model Explorer.

  1. To begin, double-click the desired project .aprx file to open ArcGIS Pro.
  2. On the ribbon, InfoWater Pro tab, Project panel, click Initialize.
  3. On the InfoWater Pro ribbon, in the Edit panel, click the Select tool.

To view the demand and pressure for a selected junction:

  1. Select any junction in the model.
    The Network map with a junction selected
  2. In the Model Explorer, click the Attribute tab.
    Model Explorer attributes for junction
  3. Zoom into the right side of the model view.
  4. Select the pump with ID P-160.
    The Map view, with Pump P-160 being selected in the network

In the Attribute tab, you can determine that this pump was flowing during the simulation because the Flow was pumping at 25.31 gpm.

Pan and zoom to the bottom-left corner of the system.

  1. Select the tank with ID T5000.
    The Map view, with Tank T5000 being selected in the network

The % Volume field shows it at 66.67% full. To check the rate that this tank is filling or draining, look at the Flow field. The result shows 970.96 gpm. This amount is positive, an indication that the tank is filling. A negative amount would have indicated that the tank is draining.

The Model Explorer attributes for tank T5000, with the Flow and % Volume highlighted

Was this information helpful?